ROBOTC.net forums
http://robotc.net/forums/

IR receiver and Power Functions remote?
http://robotc.net/forums/viewtopic.php?f=1&t=11460
Page 1 of 1

Author:  lms702 [ Mon Jun 08, 2015 2:34 am ]
Post subject:  IR receiver and Power Functions remote?

I have the HiTechnic IR Receiver and a Power Functions remote, and I'd like to know how to program a robot so that the Power Functions remote can control separate motors. I have the driver for the IR Receiver and have tried writing a program where the raw value is displayed on the screen. However, the number does not change as I use the remote. I have used the code with a touch sensor and the value changed, so I know I did something right. Help please?

Author:  mightor [ Mon Jun 08, 2015 3:43 am ]
Post subject:  Re: IR receiver and Power Functions remote?

Ensure you are transmitting on the same channel as your program is expecting the commands to be sent on.

= Xander

Author:  lms702 [ Mon Jun 08, 2015 6:31 pm ]
Post subject:  Re: IR receiver and Power Functions remote?

I am sorry, but how would I do that? I mean I know how to switch the channels on the remote but how do I set the program to expect a certain channel? Could you direct me to a place that shows how to configure the IR receiver?

Author:  lms702 [ Tue Jun 09, 2015 5:00 am ]
Post subject:  Re: IR receiver and Power Functions remote?

Nevermind. I found your example and worked from there.

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/