In the standard NXT firmware from LEGO you can create small 5-step programs that allow you to instantly power motors or test sensors. The screen for this appears on the NXT with the RobotC firmware installed but I can't seem to make the programs execute.

Does RobotC support the "Try Me" function found on the standard NXT firmware?

Thanks,
Mark

Yes. It does. This function was temporarily "broken" and removed in some of the earlier versions of ROBOTC. I cannot recall in which release it was fixed and "reappeared" but it was sometime earlier this fall.

Thanks Dick - I installed the latest firmware and the "NXT Program" function has been restored as you mention.

Regards,
Mark