I have two servos I need to move only while a touch sensor is pressed. Since you have to specify a position value for it to reach, I have no clue how to accomplish this. Also is there a way to slow the servo rate down? I tried ServoChangeRate and set it to 1 but it still ran at full speed.
Tue Jan 01, 2013 7:01 pm
Joined: Sun Nov 15, 2009 5:46 am Posts: 1523
Re: Need help programming servos to move...
One way to do it is to implement your own servo rate. For example:
Users browsing this forum: No registered users and 2 guests
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum