ROBOTC.net forums
http://robotc.net/forums/

Motors and Sensors Setup Window Missing Tabs
http://robotc.net/forums/viewtopic.php?f=1&t=9444
Page 1 of 1

Author:  altf46082 [ Fri Sep 26, 2014 3:01 pm ]
Post subject:  Motors and Sensors Setup Window Missing Tabs

I'm currently having an issue with RobotC. This is probably a really silly problem, but I'm relatively new to this. When I open my Motors and Sensors Setup window, I'm missing the TETRIX Controllers and Servos tabs. I've tried changing the menu level and looking it up and I just can't figure it out!
Thanks for your time.

Team 6082 :)

Author:  BurningLights [ Fri Sep 26, 2014 3:52 pm ]
Post subject:  Re: Motors and Sensors Setup Window Missing Tabs

Are you using version 4.26? If so, you need to check the "External Motor/Servo Controllers" option under the Robot->Platform Type menu. If you're using version 3.62, you need to select "LEGO NXT + TETRIX/MATRIX" for the platform type.

Author:  OliviliK [ Sat Jan 31, 2015 3:04 am ]
Post subject:  Re: Motors and Sensors Setup Window Missing Tabs

I am quite new RobotC user and my past experience is with EV3 using the LEGO motors and sensors. Now our team has completed the basic building of a new robot using TETRIX motor and servo controllers with EV3. In RobotC, I am missing the following items
- "TETRIX Controllers" tab in “Motors and Sensors Setup”
- "External Motor/Servo Controllers" option in Robot->Platform Type menu

I was planning to use 4.28 (beta) for programming of the EV3 and observed this problem. After downloading 3.64 for NXT, I did observe, that the Robot->Platform Type menu allows the selection of "LEGO NXT + TETRIX/MATRIX" option.

Question: When RobotC will have the TETRIX Controllers support available for EV3?

Cheers Olivilik

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/