ROBOTC.net forums
http://robotc.net/forums/

NXT won't power on, reset, or enter boot mode
http://robotc.net/forums/viewtopic.php?f=1&t=9477
Page 1 of 1

Author:  Bytemedwb [ Wed Oct 01, 2014 9:30 pm ]
Post subject:  NXT won't power on, reset, or enter boot mode

I was using the latest 4.X robot C and tried to update the firmware.
The NXT went into boot mode (clicking) but the Bossa driver did not
install.
Then the NXT brick went quiet.
It won't power on in any way.
I pressed the reset button in the battery base.
I pressed and held the reset button in the peg hole.
Nothing no response from the brick.
Plugging and unplugging and searching for new devices on the windows computer
does nothing.
Tried to download firmware again via both RobotC and Lego software - no device found.

Any thoughts or help is appreciated.

Author:  rockstar504 [ Thu Oct 02, 2014 8:09 am ]
Post subject:  Re: NXT won't power on, reset, or enter boot mode

Having the same issue, and I've tried all the solutions I could find on the internet, and every computer I have access to. Even tried switching it out with a good brick, but I'm not exactly sure I did that bit right. I guess I'll find out what LEGO support is like?

Author:  MHTS [ Tue Dec 16, 2014 3:55 am ]
Post subject:  Re: NXT won't power on, reset, or enter boot mode

Have you read this thread?
viewtopic.php?f=1&t=6278

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/