|RX signal from remote controller
|Page 1 of 1|
|Author:||kgrimes [ Tue Apr 07, 2009 2:17 pm ]|
|Post subject:||RX signal from remote controller|
I have different VEX controller that appears unable to receive an RX signal from any remote controller at any frequency. I have had my VEX hardware for 4 years, and used easyC for programming until now. This suspect VEX controller unit has successfully been reformatted to robot-C firmware and executed robot-C programs for 6 weeks, until now. Is there anything in software that can mess up the controllers ability to receive the RX signal?
|Author:||kgrimes [ Wed Apr 08, 2009 1:20 pm ]|
|Post subject:||Re: RX signal from remote controller|
Answer: Yes, software can disable the receiving of the RC signal. The program must contain the line: bIfiAutomomousMode = false; My students had deleted this line from their code, and didn't notice it until after doing extensive hardware troubleshooting. Silly me!
|Page 1 of 1||All times are UTC - 5 hours [ DST ]|
|Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group