View unanswered posts | View active topics It is currently Wed Nov 25, 2015 8:17 pm

Reply to topic  [ 2 posts ] 
Silent install parameters for the VEXnet Upgrade utility 
Author Message

Joined: Fri Jun 05, 2015 2:19 am
Posts: 1
Post Silent install parameters for the VEXnet Upgrade utility
Are there any Silent install command parameters for the VEXnet Upgrade utility.

I would like to install this silently on a few machines.

Fri Jun 05, 2015 2:25 am
Site Admin
Site Admin

Joined: Thu May 24, 2012 12:15 pm
Posts: 716
Post Re: Silent install parameters for the VEXnet Upgrade utility
The VEXNet Firmware Upgrade Utility is created and maintained by VEX Robotics; you'll have to contact them directly to see if there are any special command line parameters that can be used when installing the utility.

VEX Technical Support:

You can also try the standard Windows command line parameters, which should work on standard install packages:

Parameter Description
/v Passes parameters to MSI package.
/s Causes setup.exe to be silent.
/l Specifies the setup language.
/a Performs administrative installation.
/j Installs in advertise mode.
/x Performs setup uninstall.
/f Launches setup in repair mode.
/w Setup.exe waits for the installation to finish before exiting.
/qn A Windows Installer MSI parameter that causes everything but setup.exe to be silent. This sets the user interface level to zero.

Uninstall mode
Uninstall mode removes Personal Communications from your system.

Repair mode
Launching setup.exe in the repair mode checks the key file of every installed feature and reinstalls any feature that is determined to be missing, corrupt, or an older version.

Running setup.exe silently
To prevent setup.exe from displaying a progress bar, use the /s command-line parameter. To have setup run silently with no dialogs, pass the Windows Installer /qn command-line parameter through setup.exe using the /v parameter. Refer to Microsoft's documentation of command-line parameters for other /q user interface options.

Check out our Blog! And our Facebook page!
Need help? Take a look at our updated help documentation and the ROBOTC Forums.

Fri Jun 05, 2015 9:00 am
Display posts from previous:  Sort by  
Reply to topic   [ 2 posts ] 

Who is online

Users browsing this forum: No registered users and 2 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  

Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group.
Designed by ST Software for PTF.