View unanswered posts | View active topics It is currently Tue Jul 29, 2014 10:59 pm






Reply to topic  [ 1 post ] 
RobotC and ER4U arm/Robocell 
Author Message
Rookie

Joined: Thu May 01, 2014 8:52 am
Posts: 1
Post RobotC and ER4U arm/Robocell
Not sure if any of you have experience handshaking between VEX and an Intelitek ER4U. I am trying to run my VEX program started by a signal from the ER4U. I have a breadboard set up with an optoisolator to protect each circuit but I am unsure of how to incorporate the signal from the robot controller into VEX. I had it set up as a touch sensor so the robot should act as that, but RobotC doesn't see the the signal for some reason, meaning the value does not change when the program is running when looking down in the "sensors" dialog box after the output signal has been sent from the robot controller.

Any help would be greatly appreciated!


Thu May 01, 2014 8:59 am
Profile
Display posts from previous:  Sort by  
Reply to topic   [ 1 post ] 

Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  



Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group.
Designed by ST Software for PTF.