ROBOTC.net forums
http://robotc.net/forums/

Motor tunring 180 degrees
http://robotc.net/forums/viewtopic.php?f=14&t=14155
Page 1 of 1

Author:  lazerblast8 [ Tue Apr 26, 2016 8:37 am ]
Post subject:  Motor tunring 180 degrees

I am trying to get a motor to turn 180 degrees with no resistance. Its a VEX 393 Motor with a 2.5 diameter gear. I know it is simple but I don't really known were to start.

Author:  CARBOT [ Sun May 01, 2016 11:03 am ]
Post subject:  Re: Motor tunring 180 degrees

You are asking a very open ended question. If we assume you have successfully installed the RobotC software and updated the firmware, you would want to do this:
Review the if{} and while{} statements
Review the motor[x] statement to turn on/off the motor
Review the nMotorEncoder[x] statement to read/reset the encoder
Write a step by step task in English.
Write a step by step task in pseudo code (lines of English but not yet RobotC).
Write a program in RobotC.

If we on the forum gave you the program today it would minimize what you learn. Please don't hesitate to ask specific questions along the way.

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/