|How do i access acceleromiters built in the vez controller?
|Page 1 of 1|
|Author:||Sam1234 [ Fri Mar 27, 2015 4:39 pm ]|
|Post subject:||How do i access acceleromiters built in the vez controller?|
I need help figuring out how to get the acceleromiters in the controller to work. I've started a project where i use 2 motors to control the nobs on a etch-a-sketch.. I've tried to do some research on this and have not found anything that would help me. I would like to know if you need ant extra parts to control the acceleromiters built in the controller. A sample code would help a lot.
|Page 1 of 1||All times are UTC - 5 hours [ DST ]|
|Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group