Codatech RFID read error
Page 1 of 1

Author:  tcbarry [ Thu Nov 01, 2012 11:41 am ]
Post subject:  Codatech RFID read error

I am currently using the Codatech RFID sensor in a school project and using the RobotC Driver Suite. For the most part my program works, however, every so often the program returns an error message about the RFID sensor.

I used this


    if (!CTRFIDreadTransponder(CTRFID, transponderID)) {
         nxtDisplayTextLine(3, "Error reading");
         nxtDisplayTextLine(4, "from sensor!");

from the example program found in the driver suite.

The program will last for about 4 or 5 scans before returning the message. Any advice would be appreciated if you need to see my code just let me know and ill be happy to post it.

Author:  mightor [ Fri Nov 02, 2012 1:33 pm ]
Post subject:  Re: Codatech RFID read error

The sensor is a bit wonky at the best of times, so your program will have to deal with the occasional error. The developer has promised a new firmware for a few years now but no dice.

- Xander

Author:  tcbarry [ Fri Nov 02, 2012 4:09 pm ]
Post subject:  Re: Codatech RFID read error

Alright thank you very much.

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group