Help with Servo Programming
Page 1 of 1

Author:  Syaro [ Tue Oct 25, 2016 5:48 pm ]
Post subject:  Help with Servo Programming

Hello, I need help with programming a servo using a Vexnet joystick. The servo, we are using is a Futaba S3003. I'll have to program two buttons for a servo, therefore one button would go to a certain degree and then the second button would return the servo back to it's original position. I just need a sample program to go off of, since I cannot find anything on the internet to go off of.

Any advice to how to program it would be helpful too.
-Thank you

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group