View unanswered posts | View active topics It is currently Fri Oct 18, 2019 7:36 am






Reply to topic  [ 2 posts ] 
Simple question 
Author Message
Rookie

Joined: Wed Aug 27, 2014 3:40 pm
Posts: 1
Post Simple question
I am new to the world of robotics and just recently started using Robotc. I have successfully written and ran my programs but for the life of me I cannot figure out how to switch the controls back to the controller. Any help would be appreciated.


Wed Aug 27, 2014 3:45 pm
Profile
Site Admin
Site Admin

Joined: Thu May 24, 2012 12:15 pm
Posts: 722
Post Re: Simple question
Did you want to put the original remote control code back onto the Cortex? There are two ways to do this; you can either find the standard remote control program (that comes preprogrammed on the Cortex) in the 'Advanced -> ROBOTC VEX Cortex Default.c' sample program file.

Alternatively, you can also use the VEXNet Firmware Update Utility to reload the standard VEX Firmware and remote control program back onto the Cortex. This will revert the Cortex to an 'out-of-the-box' state, but will require you to go through the setup process in order to make the Cortex ROBOTC-ready in the future.

_________________
Check out our Blog! And our Facebook page!
Need help? Take a look at our updated help documentation and the ROBOTC Forums.


Tue Sep 09, 2014 4:38 pm
Profile
Display posts from previous:  Sort by  
Reply to topic   [ 2 posts ] 

Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  



Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group.
Designed by ST Software for PTF.