View unanswered posts | View active topics It is currently Fri Oct 31, 2014 7:30 am






Reply to topic  [ 2 posts ] 
Servos And Sensors 
Author Message
Rookie

Joined: Wed Apr 14, 2010 11:09 am
Posts: 6
Post Servos And Sensors
I'm fairly new to C programming, and I've only had a brief experience with easyC, which had servos listed in the menu, all I see for this are motors, so I was wondering how I would program those or would they both count as motors when using RobotC?

I also need to program an ultrasonic sensor, but I'm uncertain of how to go about that as well.

Any assistance would be greatly appreciated.


Sun Apr 18, 2010 8:10 am
Profile
Rookie

Joined: Sat Nov 22, 2008 8:06 pm
Posts: 48
Post Re: Servos And Sensors
The servos are run exactly the same as motors. The only difference is the hardware.

The sensor setup is fairly self-explanatory. Just go into the motor and sensor setup menu, and define the sensor on whatever port pin and interrupt pin you want.

Not to sound rude, but almost every answer to every question can be found by searching around the forums. Both this one and some of the Vex ones.

This thread has a link that will help you.
http://www.robotc.net/forums/viewtopic.php?f=11&t=1360


Sun Apr 18, 2010 3:17 pm
Profile
Display posts from previous:  Sort by  
Reply to topic   [ 2 posts ] 

Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  



Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group.
Designed by ST Software for PTF.